Honda Fit: ATF Filter Replacement (A/T)
-
Remove the air cleaner assembly.
-
Disconnect the ATF cooler hoses (A) from the ATF filter (B).
-
Remove the ATF filter holder (C).
-
Remove the ATF filter, and replace it.
-
Install the new ATF filter on the filter mounting bracket (D), and secure it with its holder and bolt.
-
Slide the ATF cooler hose on the ATF filter until the hose end contacts the filter housing, and secure the hose with the clip (E) at 6пјЌ8 mm (0.24пјЌ0.31 in) (F) from the filter housing. Install the cooler hose on the other side of the ATF filter in the same manner.
-
Install the air cleaner assembly.
See also:
Address
DEST button
► Address
Enter an address to use as the destination. The state or province you are
currently in
is displayed (e.g., California).
Select an item.
The following items are av ...
Changing the Rear Wiper Blade Rubber
1. Raise the wiper arm off.
2. Pivot up the bottom end of the wiper blade
until it comes off from the wiper arm.
3. Slide the wiper blade out from the end with
the indent.
NOTICE
Avoid dro ...
Cylinder Head Inspection for Warpage
Remove the cylinder head.
Inspect the camshaft.
Check the cylinder head for warpage. Measure along the edges, and three
ways across the center:
If wa ...
Categories
