Honda Fit manuals

Honda Fit: Cylinder Head Inspection for Warpage

  1. Remove the cylinder head.

  1. Inspect the camshaft.

  1. Check the cylinder head for warpage. Measure along the edges, and three ways across the center:

    • If warpage is less than 0.08 mm (0.003 in) cylinder head resurfacing is not required.

    • Maximum resurface is limited to the cylinder head height standard as shown.

    Cylinder Head Warpage

    Standard (New):

    0.08 mm (0.003 in) max.

    Cylinder Head Height

    Standard (New):

    119.9пјЌ120.1 mm (4.720пјЌ4.728 in)

See also:

Audio Commands
The system accepts these commands on most screens. Audio* Audio on Audio off * These commands toggle the function on and off, so the command may not match your intended action. NOTE: Audio vo ...

Previous Destinations
DEST button ► Previous Destinations Select an address from a list of your 50 most recent destinations to use as the destination. The list is displayed with the most recent destination at t ...

Find Place Commands
Find nearest (specify place): Auto service center ACURA dealers HONDA dealers Gas station Hydrogen station Auto parts & electronics shop Auto repair & maintenance shop Car wash & d ...

© 2026 Copyright www.hfitinfo.com