Remove the harness holder (A).

Disconnect the hose (A).

Remove the PCV valve (B).
Install the parts in the reverse order of removal with a new 14 mm washer (C).
Installation (Part -3)
Remove the vinyl tape from the connectors.
Connect the EPS motor angle sensor 8P connector (A), torque sensor 6P connector (B) to the steering gearbox.
...
Transmission End Crankshaft Oil Seal Installation - In Car
Special Tools Required
Driver Handle, 15 x 135L 07749-0010000
Oil Seal Driver Attachment, 96 mm 07ZAD-PNAA100
Remove the transmission.
M/T model
A/T model ...
Dashboard Vent Removal/Installation
Side Vent
Click here for an interactive version of this procedure (driver's,
passenger's).
NOTE: Take care not to scratch the dashboard or its related parts.
Pull the upper portion ( ...