Honda Fit: Map Screen

See also:

Cylinder Head Inspection for Warpage
Remove the cylinder head. Inspect the camshaft. Check the cylinder head for warpage. Measure along the edges, and three ways across the center: If wa ...

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...

Rear Brake Hose Replacement
Raise and support the vehicle. Remove the rear wheel. Disconnect the brake hose (A) from the brake line (B) using a 10 mm flare-nut wrench (C). ...