Honda Fit: Water Pump Inspection
-
Remove the right front wheel.
-
Remove the splash shield.
-
Loosen the water pump pulley mounting bolts (A).
-
Remove the drive belt.
-
Remove the water pump pulley mounting bolts, then remove the water pump pulley (B).
-
Turn the water pump pulley counterclockwise, and check that it turns freely. If it does not turn freely, replace the water pump.
NOTE: When you check the water pump, you may see a small amount of ‘‘weeping'' from the bleed holes (A). This is normal.
-
Install the water pump pulley (A), and loosely install the water pump pulley mounting bolts (B).
-
Install the drive belt.
-
Tighten the water pump pulley mounting bolts.
-
Install the splash shield.
-
Install the right front wheel.
See also:
Tire and Wheel Replacement
Replace your tires with radials of the same size, load range, speed rating,
and
maximum cold tire pressure rating (as shown on the tire’s sidewall). Using tires
of a
different size or construc ...
Installation
Hold the gearbox housing using a C-clamp (A) and wooden blocks (B) to a
workbench as shown. Do not clamp the cylinder part of the gearbox housing in
a vise.
...
iPod®/USB Flash
If an error occurs while playing an iPod® or USB flash drive, you may see the
following error messages. If you cannot clear the error message, contact a
dealer.
...
Categories
