Honda Fit: Driveshaft Disassembly
Special Tools Required
- Threaded Adapter, 22 x 1.5 mm 07XAC-001010A
- Slide Hammer 5/8''-18 UNF, commercially available
- Bearing Puller, commercially available
- Boot Band Pliers, commercially available
See also:
Change Lever Clearance Inspection (M/T)
Measure the clearance between the change lever (A) and the select lever
(B) with a feeler gauge (C). If the clearance is more than the service
limit, go to step 2.
...
Secondary Shaft Disassembly, Inspection, and Reassembly (A/T)
Inspect the thrust needle bearings and the needle bearings for galling
and rough movement.
Inspect the splines for excessive wear and damage.
Check the shaft bearing s ...
Voice Control Switch Replacement (With Navigation)
SRS components are located in this area.
Review the SRS component location, and the
precautions and procedures in the SRS section before
doing repairs or service.
Remove the ...
Categories
