Honda Fit manuals

Honda Fit: Washer Reservoir Replacement

  1. Remove the front bumper.

  1. Disconnect the 2P connector (A) and tubes (B) from the washer motor (C) and the washer fluid level switch (Canada models).

    Washer Reservoir Capacity:

    2.5 L (2.6 US qt):

    USA models

    4.5 L (4.8 US qt):

    Canada models

  2. CABD
  3. Remove the washer motor from the washer reservoir (D).

  1. Remove the bolts (A) and clips (B), then remove the washer reservoir (C).

  2. AACB
  3. Install the washer reservoir in the reverse order of removal. Check the washer motor operation.

See also:

Voice Control Switch Replacement (With Navigation)
SRS components are located in this area. Review the SRS component location, and the precautions and procedures   in the SRS section before doing repairs or service. Remove the ...

Shift Lever Housing Replacement (M/T)
NOTE: Take care not to scratch the center console, dashboard, and related parts. Remove the center console. Remove the harness clamps (A). Remove the lock pin ...

Driveshaft Installatio
NOTE: Before starting installation, make sure the mating surfaces of the joint and the splined section are clean. Apply about 5 g (0.18 oz) moly 60 paste (P/N 08734-0001) to the contact ar ...

© 2026 Copyright www.hfitinfo.com