Honda Fit: Rear Seat Removal/Installation
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to scratch the trim and panels.
-
Have an assistant help you when removing and installing the rear seat.
-
Lift both rear seat cushions up.
-
Pull the rear seat belt buckles (A) and rear center seat belt detachable anchor (B) out through the elastic straps (C) on the seat cushions.
-
Remove the clips on the seat-back hinges. Place the seat belt buckles and the seat belt detachable anchor on the floor underneath the seat cushions.
-
Fold both rear seat-backs.
-
Lift up the cargo floor lids (A), and remove the bolts securing both rear seats.
-
Remove the right rear seat (A) and the left rear seat (B) through both rear door opening.
-
Install the seats in the reverse order of removal, and note these items:
-
Push the clips into place securely.
-
After installing, fix the seat belt buckles and the detachable anchor with elastic straps on both seat cushions.
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
See also:
Compatible iPod® and USB Flash Drives
iPod® Model Compatibility
This system may not work with all software versions
of these devices.
USB Flash Drives
• Use a recommended USB flash drive of 256 MB or higher.
• Some digital aud ...
Wheel Runout Inspection
Raise and support the vehicle.
Check for a bent or deformed wheel.
Set up the dial gauge as shown, and measure the axial runout by turning
the wheel.
...
A/T Differential Carrier Bearing Preload Inspection (A/T)
Special Tools Required
Driver Handle, 15 x 135L 07749-0010000
Bearing Driver Attachment, 72 x 75 mm 07746-0010600
Preload Inspection Tool 07HAJ-PK40201
NOTE: If the transmission housing, torq ...
Categories
