Driver's seat: Pull out the side airbag harness (A) through the harness holes (B) in the seat-back pad (C) and the seat-back cover (D).
Pinch the tabs (A) on the end of the head restraint guides (B), and remove the guides from the seat-back.
Remove the seat-back cover/pad (A) from the seat-back frame (B).
Remove airbag attachment wire A from the outside reinforcing cloth (C), and remove airbag attachment wire B from the inside reinforcing cloth (D).
Install the cover in the reverse order of removal, and note these items:
Before installing the seat-back cover/pad, make sure airbag attachment wires A and B are installed correctly in the reinforcing cloths (C).
Reinstall airbag attachment wires A and B securely.
Use only original Honda replacement seat-back cover/pads.
Make sure the side airbag harness and the ODS unit harness (passenger's seat) are routed properly.
Mainshaft Bearing and Oil Seal Replacement (M/T)
Special Tools Required
Driver Handle, 15 x 135L 07749-0010000
Bearing Driver Attachment, 37 x 40 mm 07746-0010200
Bearing Driver Attachment, 52 x 55 mm 07746-0010400
Adjustable Bearing Puller, ...
HFL Menus
The ignition switch must be in ACCESSORY
or ON
to use HFL.
To use HFL, you must first pair your Bluetooth-compatible cell phone to the
system while the vehicle is parked.
Phone Setup
...
Display and Volume Settings
INFO button
► Setup
Use the Main Setup screen to adjust the display and volume.
Select or
to adjust the desired
item.
The following items are available:
• Brightness: Adjusts the s ...