Honda Fit: ODS Unit Replacement
Removal
-
Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.
-
Disconnect the passenger's side airbag harness 2P connector.
-
Remove the front passenger's seat-back cover/pad.
-
Remove the cover (A), then disconnect the ODS unit 18P connector (B) and OPDS sensor connectors (C) from the ODS unit (D).
-
Remove the two bolts (E) and the ODS unit.
Installation
-
Place the ODS unit (A) on the seat-back frame. Tighten the two bolts (B).
-
Connect the ODS unit harness 18P connector (C) and OPDS sensor connectors (D) to the ODS unit. Reinstall the cover (E).
-
Install the front passenger's seat-back cover.
-
Install the front passenger's seat assembly, then connect the side airbag harness 2P connector.
-
Do the battery terminal reconnection procedure.
-
Set the seat-back in the normal position, and make sure there is nothing on the front passenger's seat.
-
Clear any DTCs with the HDS.
-
Do the OPDS sensor initialization.
-
Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.
See also:
Front Seat Removal/Installation
Special Tools Required
KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call
888-424-6857
Click here for an interactive version of this procedure (d ...
Side Vent
Click here for an interactive version of this procedure (driver's,
passenger's).
NOTE: Take care not to scratch the dashboard or its related parts.
Pull the upper portion (A) of the s ...
Headlight Bulbs
When replacing, use the following bulbs.
High/Low beam headlight: 60/55 W (HB2)
NOTICE
Halogen bulbs get very hot when lit.
Oil, perspiration, or a scratch on the glass can cause
the bulb to ov ...
Categories
