Release the hooks (A), then pull the mirror base cover (B) down.
Pull the hook (A) down to release it from the mount (B), and slide the mirror base (C) rearward, then remove the rearview mirror (D).
Install the mirror base cover on the mirror base securely.
Fit the mirror base (A) over the mount (B), and secure the rearview mirror with the spring (C) and hook (D).
As required by the FCC
1)This device complies with Part 15 of the
FCC Rules and Canadian RSS-210/RSSGen.
Operation is subject to the following
two conditions: (1) this device may not
cause harmful interference, and (2 ...
Brightness Control
When the parking lights are turned on and the
ignition switch is in ON , you can
use the
(select/reset) knob to adjust
instrument
panel brightness.
Brighten: Turn the knob to the right.
...
A/T Housing Reverse Idler Gear Installation (A/T)
Lightly coat the reverse idler gear shaft (A), the needle bearing (B),
and new O-rings (C) with lithium grease.
Assemble the new O-rings and the needle bearing on the reverse ...