Honda Fit: Tailgate Lock Cylinder Replacement
For Some Models
NOTE: Put on gloves to protect your hands.
-
Remove the tailgate lower trim panal.
-
Disconnect the tailgate cylinder rod (A).
NOTE: Check for damaged or stress-whitened rod fastener (B).
-
Remove the bolts securing the lock cylinder (A), then remove the lock cylinder by turning it.
-
Install the lock cylinder in the reverse order of removal, and note these items:
-
Make sure the cylinder rod is connected properly.
-
Make sure the tailgate opens properly and locks securely.
-
See also:
How to Refuel
1. Stop your vehicle with the service station
pump on the left side of the vehicle in the
rear.
2. Turn off the engine.
3. Press the area indicated by the arrow to
release the fuel fill door. Y ...
Safety Labels
Label Locations
These labels are in the locations shown. They warn you of potential hazards
that can cause serious injury or death. Read these labels
carefully.
If a label comes off o ...
Transmission Side - Release Bearing Installation
Apply high temp urea grease (P/N 08798-9002) to the release fork (A), the
release fork bolt (B), the release bearing (C), and the release bearing
guide (D) in the shaded areas, then set th ...
Categories
