Inspection
Install the flange nut on the damper shaft end, and set the socket wrench
and T-handle on the nut.
Compress the damper assembly by hand, and check for smooth operation
through ...
Front Lower Arm Removal/Installation
Special Tools Required
Ball Joint Thread Protector, 14 mm 071AF-S3VA000
Ball Joint Remover, 28 mm 07MAC-SL0A202
notice
Do not remove the lower arm from both sides a ...
M/T Differential Backlash Inspection (M/T)
Place the differential assembly on V-blocks (A), and install the right
driveshaft (B) and the left driveshaft (C).
Measure the backlash of both pinion gears (D) with a dial in ...