Honda Fit manuals

Honda Fit: Interior Trim Removal/Installation - Cargo Area

Second generation (2007-2026) / Honda Fit 2007-2026 Repair Manual / Body / Body Interior / Interior Trim Removal/Installation - Cargo Area

Special Tools Required

NOTE:

  1. Release the hooks (A), then pull up the cargo floor (B) and remove it.

  2. Without spare tire

    ABAC

With spare tire

ABACCB???
  1. Release the bungee (C).

  1. Remove the tailgate weatherstrip, as needed.

  1. With temporary repair kit (TRK): Remove the cargo floor box (A)

  2. A
  1. Remove the rear trim panel (A).

    1. Disengage the tabs (B) and hooks (C) on both sides from both cargo area side trim panel (D).

    1. Detach the clips by pulling the panel up.

  2. Fastener Locations: Clip, 4(Gray)DBCACB
  1. Install the trim in the reverse order of removal, and note these items:

    • If the clips are damaged or stress-whitened, replace them with new ones.

    • Push the clips, the hooks, and the tabs into place securely.

See also:

Automatic Transmission
■Creeping The engine may run at a higher idle speed and creeping increases: • Immediately after the engine starts. • When the heating and cooling system is in use. Keep the brake pedal f ...

Intermediate Shaft Reassembly (A/T)
Exploded View Special Tools Required Oil Seal Driver, 65 mm 07JAD-PL90100 Bearing Driver Attachment, 52 x 55 mm 07746-0010400 Bearing Driver Attachment, 35 mm I.D. 07746-0030400 Drive ...

Inspection
Install the nut on the damper shaft end, and set the socket wrench and T-handle on the nut. Compress the damper assembly by hand, and check for smooth operation through a full ...

© 2026 Copyright www.hfitinfo.com