NOTE: Before replacing the gauge control module, retrieve the ODO value and the maintenance minder information from the gauge control module with the HDS.
Remove the instrument panel.
Remove the four screws from the gauge control module (A).
Disconnect the 32P connector (B) from the gauge control module.
Install the gauge control module in the reverse order of removal.
Write the ODO value and maintenance minder information to the new gauge control module.
Transmission Side - Release Bearing Inspection
Check the play of the release bearing by spinning it by hand. If there is
excessive play or noise, replace the release bearing.
NOTE: The release bearing is packed with grease. Do not ...
Authorized Manuals
Purchasing Factory Authorized Manuals (U.S. onl
The publications shown below can be purchased from Helm Incorporated. You can
order by phone or online:
• Call Helm Inc. at 1-800-782-4356 (credit ...
Airbag and Tensioner Disposal
Special Tools Required
Deployment Tool 07AAZ-000A100
Before scrapping any airbags, side airbags, side curtain airbags, seat belt
tensioners (including those in a whole vehicle to be scrapped) ...