Honda Fit: Front Door Glass Outer Weatherstrip Replacement
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to scratch the door and related parts.
-
Lower the glass fully.
-
Remove the door sash outer trim.
-
While lifting the rear of the door glass outer weatherstrip (A), slide the weatherstrip rearward, then remove the weatherstrip.
-
Install the weatherstrip in the reverse order of removal, and note these items:
-
Push the weatherstrip into place securely.
-
Make sure that there is no clearance between the rear edge of the weatherstrip and the door sash outer trim.
-
See also:
A/T Secondary Shaft Sealing Ring Replacement (A/T)
The sealing rings are synthetic resin with chamfered ends. Check the
condition of the sealing rings, and replace them only if they are worn,
distorted, or damaged.
For a better fit, squeeze ...
Front Lower Arm Removal/Installation
Special Tools Required
Ball Joint Thread Protector, 14 mm 071AF-S3VA000
Ball Joint Remover, 28 mm 07MAC-SL0A202
notice
Do not remove the lower arm from both sides a ...
Adding Engine Oil
1. Unscrew and remove the engine oil fill cap.
2. Add oil slowly.
3. Reinstall the engine oil fill cap, and tighten
it securely.
4. Wait for three minutes and recheck the
engine oil dipstick.
...
Categories
