Honda Fit: Hood Opener Cable Replacement
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to scratch the body or its related parts.
-
Remove these items:
-
Front grille cover
-
Front inner fender, left side as needed
-
Driver's dashboard undercover
-
Kick panel, driver's side
-
-
Disconnect the hood opener cable (A) from the hood latch (B).
-
Remove the hood release handle (C), and disconnect the hood opener cable.
-
Detach the clips (D) with a clip remover, release the hood opener cable from the clip (E), and remove the grommet (F) from the body, then remove the hood opener cable from the vehicle. Take care not to kink the cable.
-
Install the cable in the reverse order of removal.
NOTE: If the clips are damaged or stress-whitened, replace them with new ones.
See also:
Fuel Economy
Improving Fuel Economy
Fuel economy depends on several conditions, including driving conditions,
your
driving habits, the condition of your vehicle, and loading. Depending on these
and
other co ...
Transmission End Cover ATF Feed Pipe Replacement (A/T)
Remove the snap ring (A), the 3rd clutch feed pipe (B), and the feed pipe
flange (C) from the end cover (D).
Install a new O-ring (E) over the 3rd clutch feed pipe.
In ...
Transmission Side - Release Bearing Installation
Apply high temp urea grease (P/N 08798-9002) to the release fork (A), the
release fork bolt (B), the release bearing (C), and the release bearing
guide (D) in the shaded areas, then set th ...
Categories
