Honda Fit: Hood Assembly

See also:

Driveshaft Installatio
NOTE: Before starting installation, make sure the mating surfaces of the joint and the splined section are clean. Apply about 5 g (0.18 oz) moly 60 paste (P/N 08734-0001) to the contact ar ...

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...

Clutch Disc Inspection and Removal
Remove the clutch disc (A), the remover handle (B), and the clutch alignment shaft (C). Inspect the lining of the clutch disc for signs of slipping or oil. If the clutch di ...