Honda Fit: HFL Switch Replacement
SRS components are located in this area. Review the SRS component location, and the precautions and procedures in the SRS section before doing repairs or service.
-
Remove the steering wheel.
-
Remove the audio remote switch.
-
Remove the switch cover (A) from the voice control switch (B).
-
Remove the screws (A), and remove the set plate (B).
-
Remove the screws (C), and remove the voice control switch (D).
-
Install the voice control switch in the reverse order of removal.
See also:
A/T Housing Reverse Idler Gear Installation (A/T)
Lightly coat the reverse idler gear shaft (A), the needle bearing (B),
and new O-rings (C) with lithium grease.
Assemble the new O-rings and the needle bearing on the reverse ...
Output Shaft (Countershaft) Speed Sensor Replacement (M/T)
M/T
Raise the vehicle on a lift.
Disconnect the output shaft (countershaft) speed sensor connector (A).
Remove the output shaft (countershaft) speed sensor (B).
...
VSA® (Vehicle Stability Assist), aka ESC (Electronic Stability Control),
System
VSA® helps to stabilize the vehicle during cornering if the vehicle turns
more or less
than what was intended. It also assists in maintaining traction on slippery
surfaces.
It does so by regu ...
Categories
