Disconnect the 2P connector (A) from the clutch pedal position switch (B).
Loosen the locknut (C), then remove the clutch pedal position switch.
Install the clutch pedal position switch, and adjust the pedal height.
Mainshaft Reassembly (M/T)
Exploded View
Special Tools Required
Driver Handle, 40 mm I.D. 07746-0030100
Bearing Driver Attachment, 30 mm I.D. 07746-0030300
NOTE: Refer to the Exploded Viewas neededduring this proc ...
Warranty Coverages
U.S. Owners
Your new vehicle is covered by these warranties:
New Vehicle Limited -covers your new vehicle, except for the battery,
emissions control systems, and accessories against defects in mat ...
Wheel Runout Inspection
Raise and support the vehicle.
Check for a bent or deformed wheel.
Set up the dial gauge as shown, and measure the axial runout by turning
the wheel.
...