The destination icon shows only the approximate location of a destination address. This occurs if the number of possible addresses is different from the number of actual addresses on a block. For example, the address 1425 on a 1400 block with 100 possible addresses (because it is followed by the 1500 block) will be shown a quarter of the way down the block by the system. If there are only 25 actual addresses on the block, the actual location of address 1425 would be at the end of the block.
Secondary Shaft Disassembly, Inspection, and Reassembly (A/T)
Inspect the thrust needle bearings and the needle bearings for galling
and rough movement.
Inspect the splines for excessive wear and damage.
Check the shaft bearing s ...
Avoiding Streets
DEST button (when en route)
►Avoid Streets
Select a street or streets along your route to avoid.
1. Select the street you want to avoid.
► Repeat the procedure to avoid
other ...
Mainshaft Thrust Clearance Adjustment (M/T)
Special Tools Required
Mainshaft Base 07GAJ-PG20130
Collar 07GAJ-PG20120
Mainshaft Holder 07GAJ-PG20110
Remove the 72 mm shim (A) and oil guide plate M from the transmission
housing ...