Honda Fit: Changing the Rear Wiper Blade Rubber
1. Raise the wiper arm off.
2. Pivot up the bottom end of the wiper blade until it comes off from the wiper arm.
3. Slide the wiper blade out from the end with the indent.
NOTICE
Avoid dropping the wiper blade; it may damage the rear window.
4. Remove the retainers from the rubber blade that has been removed, and mount to a new rubber blade.
5. Slide the wiper blade onto the holder.
► Make sure it is engaged correctly, then install the wiper blade assembly onto the wiper arm.
See also:
Viewing the Route
Map Screen
After calculating the route to your
destination, the route is displayed on
the map screen.
As you drive, the system tracks your
position on the map in real time and
provides guida ...
Horn Test/Replacement
'09-11 models
Remove the front grille cover.
Disconnect the 1P connector (A) from the horn (B).
@font-face{font-family:
"Honda_SymbolMark ...
Emissions Testing
Testing of Readiness Codes
If you take your vehicle for an emissions test shortly after the battery has
been disconnected or gone dead, it may not pass the test.
This is because of certain ‘‘r ...
Categories
