Checking Wiper Blades
If the wiper blade rubber has deteriorated, it will leave streaks and the metal wiper arm may scratch the window glass
Reverse Shift Fork Clearance Inspection (M/T)
Measure the clearance between the reverse idler gear (A) and the reverse
shift fork (B) with a feeler gauge (C). If the clearance is more than the
service limit, go to step 2.
...
Output Shaft (Countershaft) Speed Sensor Replacement (M/T)
M/T
Raise the vehicle on a lift.
Disconnect the output shaft (countershaft) speed sensor connector (A).
Remove the output shaft (countershaft) speed sensor (B).
...
Emissions Testing
Testing of Readiness Codes
If you take your vehicle for an emissions test shortly after the battery has
been disconnected or gone dead, it may not pass the test.
This is because of certain ‘‘r ...