Honda Fit: Fuel System

See also:

Piston Installation
If the Crankshaft is Already Installed Set the crankshaft to bottom dead center (BDC) for each cylinder as its piston is installed. Remove the connecting rod caps, and check that ...

Block and Piston Inspection
Remove the crankshaft and the pistons. Check the piston for distortion or cracks. Measure the piston skirt diameter (A) at a point 16 mm (0.63 in)   from ...

Pressure Plate Inspection and Removal
Remove the transmission. Check the evenness of the height of the diaphragm spring fingers using the clutch alignment disc (A), clutch alignment shaft (B), remover handle (C ...