Honda Fit: Engine

See also:

Installation (Part -3)
Remove the vinyl tape from the connectors. Connect the EPS motor angle sensor 8P connector (A), torque sensor 6P connector (B) to the steering gearbox. ...

Ball Joint Boot Inspection/Replacement
Special Tools Required Bearing Driver Attachment, 40 mm 07GAF-SE00200 Check the ball joint boot for weakness, damage, cracks, and grease leaks. NOTE: If the ball joint boot is ...

Recirculation Control Cable Adjustment
Open the glove box. Release the glove box stop on each side, then let the glove box hang down. Set the recirculation control lever to FRESH (). Detach the recirculation ...