This section describes how to enter a destination, select a route to take, and follow the route to your destination. It also describes how to change your route or destination along the way.
Output Shaft (Countershaft) Speed Sensor Replacement (A/T)
Remove the air cleaner assembly.
Disconnect the output shaft (countershaft) speed sensor connector, and
remove the output shaft (countershaft) speed sensor (A).
...
Transmission Side - Release Bearing Inspection
Check the play of the release bearing by spinning it by hand. If there is
excessive play or noise, replace the release bearing.
NOTE: The release bearing is packed with grease. Do not ...
Alternator Brush Inspection
Measure the length of both brushes (A) with a vernier caliper:
If either brush is shorter than the service limit, replace the brushes,
go to step
20.
If brush length ...