Honda Fit: System Setup

See also:

Transmission Side - Release Bearing Installation
Apply high temp urea grease (P/N 08798-9002) to the release fork (A), the release fork bolt (B), the release bearing (C), and the release bearing guide (D) in the shaded areas, then set th ...

Engine Does Not Start
Checking the Engine If the engine does not start, turn the ignition switch to START and check the starter. If you must start the vehicle immediately, use an assisting vehicle to jump start it. ...

Clutch Disc and Pressure Plate Installation
Temporarily install the clutch disc onto the splines of the transmission mainshaft. Make sure the clutch disc slides freely on the mainshaft. Apply a light coat of super high temp ...