Honda Fit: A/T Housing Idler Gear Shaft Removal and Installation (A/T)
-
Remove the snap ring (A), the cotter retainer (B), and the cotters (C) from the idler gear shaft (D), then remove the idler gear shaft. Do not distort the snap ring.
-
Check the snap ring and the cotter retainer for wear and damage. Replace the snap ring and/or the cotter retainer if the snap ring or the cotter retainer is worn, distorted, or damaged.
-
Install the idler gear shaft in the idler gear shaft bearing.
-
Install the cotters and cotter retainer, and secure the idler gear shaft with the snap ring.
See also:
Front Brake Hose Replacement
Raise and support the vehicle.
Remove the front wheel.
Disconnect the brake line (A) from the brake hose (B), then remove the brake
hose bracket (C).
...
Output Shaft (Countershaft) Speed Sensor Replacement (M/T)
M/T
Raise the vehicle on a lift.
Disconnect the output shaft (countershaft) speed sensor connector (A).
Remove the output shaft (countershaft) speed sensor (B).
...
Door Locks
Each door has a lock tab on the top of the door. Push in the tab to lock the
door, and pull it out to unlock.
On Canadian DX model
To lock the passenger’s door when getting out of the vehicle, ...
Categories
