Honda Fit: Engine Oil/Air Separator Installation
-
Remove all of the old liquid gasket from the oil/air separator mating surfaces, the bolts, and the bolt holes.
-
Clean and dry the oil/air separator mating surfaces.
-
Apply liquid gasket (P/N 08717-0004, 08718-0003, 08718-0004, or 08718-0009) to the engine block mating surface of the oil/air separator and to the inside edge of the threaded bolt holes. Install the component within 5 minutes of applying the liquid gasket.
NOTE:
-
Apply a 1.5 mm (0.059 in) diameter bread of liquid gasket along the broken line (A).
-
If you apply liquid gasket P/N 08718-0012, the component must be installed within 4 minutes.
-
If too much time has passed after applying the liquid gasket, remove the old liquid gasket and residue, then reapply new liquid gasket.
-
-
Install the oil/air separator (A).
NOTE:
-
Wait at least 30 minutes before filling the engine with oil.
-
Do not run the engine for at least 3 hours after installing the oil/air separator.
-
-
Install the PCV hose (B).
See also:
Engine Does Not Start
Checking the Engine
If the engine does not start, turn the ignition switch to START
and check the
starter.
If you must start the vehicle immediately, use an
assisting vehicle to jump start it. ...
If the EPS System Indicator Comes On
■ Reasons for the indicator to come on
• Comes on when there is a problem with EPS system.
• If you depress the accelerator pedal repeatedly to increase the engine
speed while the engin ...
Braking System
Your vehicle is equipped with front disc brakes. The brakes on the rear wheels
are drum. A power assist helps reduce the effort needed on the brake pedal. The
anti-lock brake system (ABS) helps yo ...
Categories
