Honda Fit: General

See also:

Fuel Tank Replacement
Drain the fuel tank until it is less than half full. Reinstall the fuel tank unit without connecting the fuel tank unit 4P connector and the quick-connect fitting (feed l ...

Valve Inspection
Remove the valves. Measure the valve in these areas. Intake Valve Dimensions A Standard (New): 27.85пјЌ28.15 mm (1.0965пјЌ1.108 ...

Pressure Plate Inspection and Removal
Remove the transmission. Check the evenness of the height of the diaphragm spring fingers using the clutch alignment disc (A), clutch alignment shaft (B), remover handle (C ...