Honda Fit: Water Outlet Removal and Installation

See also:

Transmission End Cover Transmission Fluid Pressure Switch Replacement (A/T)
Remove the transmission fluid pressure switch A (2nd clutch) (A). Make sure there is no water, oil, dust, or foreign particles inside the connector. Install the new tr ...

Transmission Side - Release Bearing Inspection
Check the play of the release bearing by spinning it by hand. If there is excessive play or noise, replace the release bearing. NOTE: The release bearing is packed with grease. Do not ...

Cylinder Head Installation
Clean the cylinder head and the engine block surface. Install a new coolant separator (A) in the engine block whenever the engine block is replaced. Install a new ...