Honda Fit manuals

Honda Fit: Installation

Second generation (2007-2025) / Honda Fit 2007-2025 Repair Manual / Electrical / Charging / Alternator / Generator / Alternator Removal and Installation / Installation

  1. Install the alternator (A), then tighten the alternator mounting bolts (B).

    2. B8 x 1.25 mm24 N·m (2.4 kgf·m, 17 lbf·ft)B8 x 1.25 mm24 N·m (2.4 kgf·m, 17 lbf·ft)A

  1. Connect the alternator connector (A) and the positive alternator cable (B). Make sure the crimped side of the ring terminal faces away from the alternator when you connect it.

    2. ABC6 x 1.0 mm8 N·m (0.8 kgf·m,6 lbf·ft)

  2. Install the harness clamp (C) to the alternator.

  3. Install the intake manifold.

  4. Install the drive belt.

  5. Do the battery terminal reconnection procedure.

See also:

Rear Seat Cushion Leg Replacement
NOTE: Take care not to tear or damage the seat covers. Put on gloves to protect your hands. Take care not to kink the cable. The left rear seat cushion is shown, the rig ...

Controls
Turn Signals Turn Signal Control Lever Lights Light Control Switches Wipers and Washers Wiper/Washer Control Lever MIST OFF INT: Low speed with intermittent LO: Low speed wipe HI: High ...

Lower Front Bumper Grille Replacement
Special Tools Required KTC Trim Tool Set SOJATP2014 *Available through the Honda Tool and Equipment Program; call 888-424-6857 With Front Fog Lights NOTE: Take care not to scratch ...

Categories

© 2025 Copyright www.hfitinfo.com