Honda Fit: VSA Off Switch Test/Replacement
NOTE: If the low tire pressure indicator turns ON, the VSA cannot be turned OFF. Check the tire pressure first.
-
Turn the ignition switch to LOCK (0).
-
Remove the driver's dashboard lower cover.
-
Push out the VSA OFF switch (A) from the driver's dashboard lower cover.
-
On the switch side, check for continuity between VSA OFF switch 5P connector terminals No. 1 and No. 2. There should be continuity when the button is released, and no continuity when the button is pressed.
-
On the switch side, check for continuity between VSA OFF switch 5P connector terminals No. 4 and No. 5. There should be continuity at all times.
-
If the continuity is not as specified, remove the cover (A), and replace the bulb (B).
-
Install the VSA OFF switch in the reverse order of removal.
See also:
Carpet Replacement
Special Tools Required
KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call
888-424-6857
SRS components are located in this area.
Review the SRS c ...
Map Matching
Map matching is the process of using the
acquired GPS information to locate your
position on the map screen. If you are on a
mapped road, the name of the road is
displayed along the bottom of the ...
Front Inner Fender Replacement
NOTE:
Put on gloves to protect your hands.
Take care not to scratch the body.
For some models:
Remove the side sill panel.
Remove the front inner fender (A).
...
Categories
