Honda Fit: Cable Reel Replacement

Removal

1. Make sure the front wheels are aligned straight ahead.

1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

1. Remove the driver's airbag.

4. Disconnect the cable reel 20P connector (A) from the cable reel, then remove the steering wheel bolt (B).

5. Confirm that the front wheels point straight ahead, then remove the steering wheel with a steering wheel puller. Do not tap on the steering wheel or steering column shaft when removing the steering wheel.

6. Remove the column covers.

7. Disconnect the cable reel 4P connector (A) and the cable reel 20P connector (B) from the cable reel (C).

8. Release the lock tab (A) under the cable reel connector with a 90

   See also:

   Headliner Removal/Installation (General information)
   Special Tools Required KTC Trim Tool Set SOJATP2014 *Available through the Honda Tool and Equipment Program; call 888-424-6857 SRS components are located in this area. Review the SRS ...

   Rear Seat Belt Replacement
   Rear Seat Belt NOTE: Check the rear seat belts for damage, and replace them if necessary. Remove these items: Rear door inner seal, as needed Tailgate weatherst ...

   Vehicle Identification Number (VIN)
   Your vehicle has a 17-digit vehicle identification number (VIN) used to register your vehicle for warranty purposes, and for licensing and insuring your vehicle. See the image below for the VIN ...