Charging the Battery
Disconnect both battery cables to prevent damaging your vehicle’s electrical
system.
Always disconnect the negative (–) cable first, and reconnect it last. ...
Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque
its locknut to 110 N·m (11.2 kgf·m, 81 lbf·ft).
Remove any grease or any oil from the ...
Crankshaft Main Bearing Replacement
Main Bearing Clearance Inspection
Remove the bearing cap bridge, the main bearing caps, and main bearing
halves.
Clean each main journal and main bearing half with a clean s ...