Honda Fit: Exploded View
Special Tools Required
- Ball Joint Remover, 28 mm 07MAC-SL0A202
- Hub Dis/Assembly Pin, 40 mm 07GAF-SE00100
- Driver Handle, 15 x 135L 07749-0010000
- Bearing Driver Attachment, 52 x 55 mm 07746-0010400
- Support Base 07965-SD90100
- Ball Joint Thread Protector, 10 mm 07AAF-SECA120
- Ball Joint Thread Protector, 14 mm 071AF-S3VA000
See also:
MAP Sensor Replacement
Disconnect the MAP sensor connector (A).
Remove the MAP sensor (B).
Install the parts in the reverse order of removal with a new O-ring (C).
...
Emergency Towing
Call a professional towing service if you need to tow your vehicle.
■ Flat bed equipment
The operator loads your vehicle on the back of a truck.
This is the best way to transport your veh ...
Transmission End Cover Transmission Fluid Pressure Switch Replacement (A/T)
Remove the transmission fluid pressure switch A (2nd clutch) (A).
Make sure there is no water, oil, dust, or foreign particles inside the
connector.
Install the new tr ...
Categories
© 2026 Copyright www.hfitinfo.com