Honda Fit: Removal (Part -2)
-
Remove the harness clamp (A) from its clamp bracket (B) located in front of the left damper top.
-
Set up the engine support hanger (AAR-T1256). Carefully position the engine support hanger to the vehicle; position both cross-arm foot bases (C) over the harness clamp brackets on both sides, and position both front stands on the front bulkhead. Attach the hook to the universal eyelet, tighten the wing nut by hand, and lift and support the engine.
-
Disconnect the EPS motor angle sensor 8P connector (A) and torque sensor 6P connector (B) from the steering gearbox.
-
Disconnect the EPS motor 3P connector (C) by pushing the lock (D) and pulling up the lever (E).
-
Wrap the connectors with vinyl tape to avoid contamination from grease or water.
-
Remove the front cross-member brace (A).
See also:
Audio
This section describes how to operate the audio system. You can play
music from a wide array of media sources, and control the audio system
using the audio buttons, the touch screen, or voice contro ...
Safety Labels
Label Locations
These labels are in the locations shown. They warn you of potential hazards
that can cause serious injury or death. Read these labels
carefully.
If a label comes off o ...
Canceling the Route
DEST button (when en route)
►Cancel Route
Cancel the route guidance and remove the destination and all waypoints from
the
destination list. The system then returns to the map screen.
You ...
Categories
