Honda Fit: Front Passenger's Airbag Replacement (Installation)
Installation
-
Insert the hooks (A) of the front passenger's airbag housing into the new front passenger's lid, then insert the other hooks (B) into the panel.
NOTE:
-
Make sure there are no objects between the airbag and the front passenger's lid.
-
Make sure the airbag is fully seated, and make sure the front passenger's lid is not deformed or damaged after the airbag is in place.
-
Make sure the hooks are set properly.
-
-
Place the front passenger's airbag assembly (A) into the dashboard. Torque the new front passenger's airbag mounting bolts (B).
-
Install the screw (C) in the front passenger's lid.
-
Connect the front passenger's airbag inflator 4P connector (A) on the dashboard wire harness, then connect the connector clip. Reinstall the glove box.
-
Do the battery terminal reconnection procedure.
-
Clear any DTCs with the HDS.
-
After installing the front passenger's airbag, confirm proper system operation: Turn the ignition switch to ON (II), and check that the SRS indicator should comes on for about 6 seconds and then goes off.
-
Reinstall all removed parts.
See also:
Breather Line and Suction Line Inspection (Page-1)
Special Tools Required
Fuel Pressure Gauge Attachment Set 07AAJ-S6MA150
Vacuum Pump/Gauge, 0-30 inHg Snap-on YA4000A or equivalent, commercially
available
Vacuum/Pressure Gauge, 0-4 inHg 07 ...
Correct Vehicle Position
INFO button
► Setup ►Other
►Vehicle
Manually adjust the current position of the vehicle as displayed on the map
screen if
the position appears to be incorrect.
1. Put the v ...
If the Malfunction Indicator Lam Comes On or Blinks
■ Reasons for indicator lamp to come on or blink
• Comes on when there is a problem with the engine emissions control
system, or the fuel fill cap is missing, or loose.
• Blinks when en ...
Categories
