Honda Fit: Power Mirror Actuator Replacement
Removal
-
Remove these items:
-
Mirror holder
-
Power mirror
-
-
Record the power mirror connector terminals location and the wire harness colors.
-
Disassemble the power mirror connector (A), and remove the terminals (B) from the connector.
-
Remove the gasket (A) and the cover (B).
-
Remove the three screws, and separate the mirror housing (C) from the bracket (D).
-
Remove the four screws, and separate the power mirror actuator (A) from the housing (B).
Installation
-
Route the wire harness of the new actuator through the hole in the bracket and gasket, then install the parts in the reverse order of removal.
-
Insert the new actuator terminals into the connector in the original arrangement.
-
Apply tape in the areas shown (A), to seal the wire harness.
-
Reassemble in the reverse order of disassembly.
NOTE: Be careful not to break the mirror when reinstalling it to the actuator.
-
Reinstall the mirror assembly on the door.
-
Operate the power mirror to ensure smooth operation.
See also:
Editing My Destination
DEST button (when en route)
►My Destination
Delete or edit the order of waypoints.
1. Select Edit.
► Select Map to display the
destination and waypoints on
the map screen.
...
Changing the Front Wiper Blade Rubber
1. Lift the driver side wiper arm first, then the
passenger side.
2. Place a cloth on the edge of the lock tab.
Push the lock tab up with a flat-tip
screwdriver.
3. Slide the blade from the ...
Shift Fork Disassembly/Reassembly (M/T)
NOTE: Prior to reassembling, clean all the parts in solvent, dry them, and
apply MTF to all contact surfaces.
...
Categories
