Honda Fit manuals

Honda Fit: Sunvisor Removal/Installation

'9-10 models

Click here for an interactive version of this procedure.

NOTE:

  1. Insert a flat-tip screwdriver wrapped with protective tape through the hole in the front side of the bracket cover (A), and push in on the hook (B).

  2. AAAB
  1. While pushing in on the hook (A), release the sunvisor (B) from the holder (C), and rotate the sunvisor backward about 45 Ю Make sure the hook slides into the bracket cover (D) as you rotate the sunvisor.

  2. CBAEBD
  1. Pull down the sunvisor (A) to release the pin (B) and the bracket (C) from the holes in the body.

    NOTE: If the sunvisor cannot be pulled down, the hook has not rotated into the bracket cover. Repeat step 2   to rotate the hook.

  2. BCAC
  1. Turn the holder (A) 45

      See also:

      A/C Refrigerant Recovery (With A/C)
      caution Air conditioning refrigerant or lubricant vapor can irritate your eyes, nose, or throat. Be careful when connecting service equipment. ...

      Piston Installation
      If the Crankshaft is Already Installed Set the crankshaft to bottom dead center (BDC) for each cylinder as its piston is installed. Remove the connecting rod caps, and check that ...

      Wheel Speed Sensor Replacement
      Front Turn the ignition switch to LOCK (0). Remove the grommet (A), then disconnect the wheel speed sensor connector (B). @font-face{font-famil ...

    © 2026 Copyright www.hfitinfo.com