Honda Fit: Interior Trim Removal/Installation - Cargo Area
Special Tools Required
- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Release the hooks (A), then pull up the cargo floor (B) and remove it.
Without spare tire
With spare tire
-
Release the bungee (C).
-
Remove the tailgate weatherstrip, as needed.
-
With temporary repair kit (TRK): Remove the cargo floor box (A)
-
Remove the rear trim panel (A).
-
Disengage the tabs (B) and hooks (C) on both sides from both cargo area side trim panel (D).
-
Detach the clips by pulling the panel up.
-
-
Install the trim in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips, the hooks, and the tabs into place securely.
-
See also:
Fuel Pressure Relieving
Before disconnecting fuel lines or hoses, relieve pressure from the system by
disabling the fuel pump and disconnecting the fuel line/quick connect fitting in
the engine compartment.
With the HDS ...
Transmission End Cover Selector Control Shaft Oil Seal Replacement (A/T)
Special Tools Required
Driver Handle, 15 x 135L 07749-0010000
Bearing Driver Attachment, 22 x 24 mm 07746-0010800
Remove the oil seal from the end cover.
Install the new oil ...
ATF Replacement (A/T)
NOTE: Keep all foreign particles out of the transmission.
Warm up the engine to normal operating temperature (the radiator fan
comes on), and turn the engine off.
Raise the vehic ...
Categories
