Honda Fit: Interior Trim Removal/Installation - Cargo Area
Special Tools Required
- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Release the hooks (A), then pull up the cargo floor (B) and remove it.
Without spare tire
With spare tire
-
Release the bungee (C).
-
Remove the tailgate weatherstrip, as needed.
-
With temporary repair kit (TRK): Remove the cargo floor box (A)
-
Remove the rear trim panel (A).
-
Disengage the tabs (B) and hooks (C) on both sides from both cargo area side trim panel (D).
-
Detach the clips by pulling the panel up.
-
-
Install the trim in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips, the hooks, and the tabs into place securely.
-
See also:
Light Switches
Rotating the light switch turns the lights on
and off, regardless of the position of the
ignition switch.
■ High beams
Push the lever forward until you hear a click.
■ Low beams ...
Fuel Pressure Regulator Replacement
Remove the fuel tank unit.
Remove the reservoir (A).
Remove the clip (B) and the ground wire (C), then remove the bracket (D).
Remove the clip (E), then r ...
Air Cleaner Removal/Installation
Disconnect the MAF sensor/IAT sensor connector(A), then remove the air
cleaner cover (B) and the air cleaner element (C).
NOTE: Be careful not to damage the MAF sensor/IAT sensor on the air ...
Categories
