Honda Fit: Interior Trim Removal/Installation - Cargo Area
Special Tools Required
- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
-
Put on gloves to protect your hands.
-
Take care not to bend or scratch the trim and panels.
-
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
-
Release the hooks (A), then pull up the cargo floor (B) and remove it.
Without spare tire
With spare tire
-
Release the bungee (C).
-
Remove the tailgate weatherstrip, as needed.
-
With temporary repair kit (TRK): Remove the cargo floor box (A)
-
Remove the rear trim panel (A).
-
Disengage the tabs (B) and hooks (C) on both sides from both cargo area side trim panel (D).
-
Detach the clips by pulling the panel up.
-
-
Install the trim in the reverse order of removal, and note these items:
-
If the clips are damaged or stress-whitened, replace them with new ones.
-
Push the clips, the hooks, and the tabs into place securely.
-
See also:
Adjusting the Seats
WARNING
Sitting too close to a front airbag can result
in serious injury or death if the front
airbags inflate.
Always sit as far back from the front
airbags as possible while maintaining
cont ...
Installation (Part -3)
Remove the vinyl tape from the connectors.
Connect the EPS motor angle sensor 8P connector (A), torque sensor 6P connector (B) to the steering gearbox.
...
Audio Antenna
Your vehicle is equipped with an antenna at the rear of the roof . Bef ore
using a ‘‘drive-through’’ car wash, remove the antenna by unscrewing it by hand.
This prevents the antenna f ...
Categories
