Honda Fit: Fuel Pump/Fuel Gauge Sending Unit Replacement
-
Remove the fuel tank unit.
-
Remove the fuel level sensor (fuel sending unit) (A) from the fuel tank unit (B).
-
Check these items before installing the fuel tank unit:
-
When connecting the wire harness, make sure the connection is secure and the connector (C) is firmly locked into place.
-
When installing the fuel gauge sending unit, make sure the connection is secure. Be careful not to bend or twist it excessively.
-
-
Install the parts in the reverse order of removal. When installing the fuel tank unit, align the marks on the unit and the fuel tank.
See also:
Rear Seat Control Cable Replacement
NOTE:
Take care not to tear or damage the seat covers.
Put on gloves to protect your hands.
Take care not to kink the cable.
The left rear seat is shown, the right rear ...
Adjusting the Seats
WARNING
Sitting too close to a front airbag can result
in serious injury or death if the front
airbags inflate.
Always sit as far back from the front
airbags as possible while maintaining
cont ...
A/T Housing Idler Gear Shaft Removal and Installation (A/T)
Remove the snap ring (A), the cotter retainer (B), and the cotters (C)
from the idler gear shaft (D), then remove the idler gear shaft. Do not
distort the snap ring.
Check ...
Categories
