NOTE:
Put on gloves to protect your hands.
Take care not to scratch the door and related parts.
Lower the glass fully.
Remove the door sash outer trim.
While lifting the rear of the door glass outer weatherstrip (A), slide the weatherstrip rearward, then remove the weatherstrip.
Install the weatherstrip in the reverse order of removal, and note these items:
Push the weatherstrip into place securely.
Make sure that there is no clearance between the rear edge of the weatherstrip and the door sash outer trim.
Reassembly
Install the upper spring seat (A) to the upper spring seat clip (B).
NOTE: Make sure to securely set the upper spring seat to the hook (C) on
the spring seat clip.
...
Rotor Slip Ring Test
Measure the resistance between the slip rings (A):
If the resistance is within the standard, go to step
22.
If the resistance is not within the standard, replace the roto ...
Installation (Part -3)
Remove the vinyl tape from the connectors.
Connect the EPS motor angle sensor 8P connector (A), torque sensor 6P connector (B) to the steering gearbox.
...