Special Tools Required
*Available through the Honda Tool and Equipment Program; call 888-424-6857
NOTE:
Take care not to scratch the body.
Take care not to bend the roof molding.
Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
Apply protective tape (A) to the body. Pry up on the roof molding (B) with the appropriate trim tool (C).
Pull up and slide the roof molding to release the front bracket (D) from the pin (E).
Pull up the front portion of the roof molding.
Pull up and release the rear bracket (A) from the pin (B), then remove the roof molding (C).
Install the molding in the reverse order of removal, and note these items:
Take care not to damage the windshield molding.
Make sure the roof molding is installed securely.
Exterior Lights System Description
Headlights System Description
The headlight system is composed of the MICU, the headlight and dimmer/flash-to-pass
switches (inside the combination light switch), the left and right headlights, ...
Engine Coolant
Adding Engine Coolant
If the coolant level in the reserve tank is at or below the MIN line, add coolant
to bring it up to the MAX line.
Inspect the cooling system for leaks.
Always use Honda Lo ...
Shaft Assembly and Housing Installation (A/T)
Install the differential assembly in the torque converter housing.
Install the baffle plate.
Assemble the mainshaft, the countershaft, and the secondary shaft.
NO ...