Honda Fit: Emblem/Sticker Replacement
NOTE: When removing the emblems/stickers, take care not to scratch the body.
-
To remove the front ёH'' emblem, remove the front grille.
-
To remove the rear ёH'' emblem, remove the rear license trim.
-
Clean the body surface with a shop towel dampened in isopropyl alcohol. After cleaning, keep oil, grease, and water from getting on the surface.
-
Apply the emblems/sticker where shown. When installing the ULEV sticker on the inside surface of the left quarter glass, align the sticker with the edge of the glass mark as shown, then press the sticker into place, and remove the application tape.
-
After installing the front ёH'' emblem, reinstall the front grille.
-
After installing the rear ёH'' emblem, reinstall the rear license trim.
See also:
Transmission Side - Release Bearing Installation
Apply high temp urea grease (P/N 08798-9002) to the release fork (A), the
release fork bolt (B), the release bearing (C), and the release bearing
guide (D) in the shaded areas, then set th ...
DOT Tire Quality Grading (U.S. Vehicles)
The tires on your vehicle meet all U.S. Federal Safety Requirements. All
tires are
also graded for treadwear, traction, and temperature performance according
to Department of Transportation (DOT) ...
Displaying the Map Menu
Use the Map Menu to control the icons displayed on the screen. You can also
use
the Map Menu to find locations or to cancel the route.
1. On the map screen, select MAP
MENU (if displayed).
...
Categories
