Honda Fit: Taillight Replacement
-
Open the tailgate and remove the maintenance lid.
-
Disconnect the connectors (A) from the taillights (B).
-
Remove the mounting nuts from the taillight.
-
Install the taillight in the reverse order of removal.
See also:
Wiper Blades
Check the condition of the wiper blades at least every six months.
Replace them if you find signs of cracking in the rubber, areas that are getting
hard, or if they leave streaks and unwiped areas ...
Transmission Side - Release Bearing Inspection
Check the play of the release bearing by spinning it by hand. If there is
excessive play or noise, replace the release bearing.
NOTE: The release bearing is packed with grease. Do not ...
Secondary HO2S Replacement
Special Tools Required
O2 Sensor Wrench Snap-on S6176 or equivalent, commercially available
Disconnect the secondary HO2S connector (A).
Raise the vehicle on a lift.
...
Categories
