Honda Fit: Immobilizer

See also:

Alternator Reassembly
If you removed the pulley, put the rotor in the drive-end housing, then torque its locknut to 110 N·m (11.2 kgf·m,   81 lbf·ft). Remove any grease or any oil from the ...

Emissions Testing
Testing of Readiness Codes If you take your vehicle for an emissions test shortly after the battery has been disconnected or gone dead, it may not pass the test. This is because of certain ‘‘r ...

Recirculation Control Cable Adjustment
Open the glove box. Release the glove box stop on each side, then let the glove box hang down. Set the recirculation control lever to FRESH (). Detach the recirculation ...