Honda Fit manuals

Honda Fit: Ignition Switch Replacement

NOTE: SRS components are located in the area. Review the SRS component locations, and precautions and procedures   before doing repairs or servicing.

  1. Do the battery terminal disconnection procedure.

  1. Remove the steering column covers.

  1. Disconnect the 7P connector (A) from the ignition switch (B).

  2. BA
  3. Remove the two screws and the ignition switch.

  4. Install the parts in the reverse order of removal.

  5. Do the battery terminal reconnection procedure.

See also:

Fuel Pressure Relieving
Before disconnecting fuel lines or hoses, relieve pressure from the system by disabling the fuel pump and disconnecting the fuel line/quick connect fitting in the engine compartment. With the HDS ...

Recirculation Control Cable Adjustment
Open the glove box. Release the glove box stop on each side, then let the glove box hang down. Set the recirculation control lever to FRESH (). Detach the recirculation ...

Inspection
Raise and support the vehicle. Remove the front wheels. Check the thickness (A) of the inner pad (B) and the outer pad (C). Do not include the thickness of the back ...

© 2026 Copyright www.hfitinfo.com